Triple-Hormone-Receptor Agonist Retatrutide for Obesity

All PEPTIDES THAT ARE SOLD ARE lyophilized – They will need to be be reconstituted.
You will need to purchase BAC WATER and SYRINGES.

Before starting, allow the peptide and bacteriostatic water vials to reach room temperature for 30 minutes, away from direct light or heat sources.

Start by disinfecting the stoppers of both vials using alcohol prep pads.
Assemble the large sterile needle and syringe and draw in about 1mL of air. Then insert the needle into the vial with the sterile solvent.
Inject the air inside the vial to prevent negative pressure and immediately withdraw the correct amount of sterile solvent needed for reconstitution (usually 1mL).
Pull the needle out of the solvent and insert it into the vial with lyophilized peptide.
Then drip or slowly inject the solvent from the syringe while aiming the needle tip at the vial wall. To prevent foaming, do not aim directly toward the powder or spray the solvent.
Once researchers have injected the correct amount of solvent, they can dispose of the needle and syringe in a sharps container.
Let the peptide dissolve naturally within the solvent. In addition, researchers can use sonication if available or very gently roll/swirl the vial. Avoid forceful tapping or shaking, as this can damage the peptide structure. Also, avoid tapping the syringe before injection.
After the peptide has dissolved, check the clarity of the liquid and look for any particles. If the solution is cloudy or if there are any particles, discard it.
Once the peptide is reconstituted, refer to the specific product label for accurate dosage and storage instructions, if any. We ALWAYS suggest fridge for water and peptide!!